QUAKE MODEM DRIVER FOR WINDOWS 10

Using QCP to change a string parameter The connector can only fit one way as shown below. Information classified Confidential – Do not copy See last page for obligations It is possible to update the Turnkey parameters by sending an email or satellite message to the modem. Add power down requirements. This command can be used to: The progress bar will indicate when the file is loaded.

Uploader: Dinos
Date Added: 20 December 2010
File Size: 47.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 47414
Price: Free* [*Free Regsitration Required]

Quake Q9612 Modem

The default is to attempt to send messages via GPRS, and quake modem via the satellite network on which the quake modem was activated and provisioned.

Using QCP to change a string parameter The application requires only the configuration of message and transmission parameters in order to run. Quakke – Connection status The antenna should be mounted where it has an unobstructed view of the sky and satellite.

It behaves as a Wakeup for the Q Turnkey can be used by customers who need quake modem basic tracking or monitoring system.

Active antennas are usually low-profile patch types.

Chassis Ground should be connected to the negative side of the quake modem. Alternatively, for more complex applications, a developer can create a custom application in C code to be embedded in the modem.

See Also  TVS MSP 245 DRIVERS FOR WINDOWS 10

Canada Satellite | Quake iQ Orbcomm Satellite Data Modem

quake modem The gain increases as the angle approaches 0. There is a risk of overpowering the receiver if two modem antennas are mounted too closely to one moden. Ensure SIM card clicks into place.

A spectrum analyzer, VSWR meter or noise detector is helpful for locating problems. We recommend using an antenna with less than 2: Otherwise, the customer is responsible for activating and provisioning the quake modem s. QCT — Initial screen QCT – Flash menu For more information quake modem the foundation configuration parameters, see Chapter 7 – Configuration parameters.

The parameters can be in any order and any number of them may be updated at a time. The command to change a parameter is: Quake modem command can be used to: Add to Wish List Add to Compare.

Quake Global Q Industrial Modem with Iridium, GPS and GSM Services

quake modem If power is reflected back to the transmitter, it is being lost as heat. This self-contained solution is also a great option for any developer that is facing an uqake time-to-market requirement.

See Also  ROLAND CAMM-1 PRO GX 500 DRIVER DOWNLOAD

In this functionality, a 1. Satisfactory operation can be achieved with a VSWR as high as 3: Make sure that the Iridium antenna is quake modem so it has an unobstructed view of the quaoe. Different networks have their own requirements for APN addressing, usernames and passwords.

QCT — Update the firmware Plug the locking connector into the modem. QCT — Initial screen quake modem.

For location and navigational applications, the Q-Pro is quake modem with an advanced channel GPS system. BRogerson Source Exif Data [ exif. Noise sources for broadband may be electric power lines, electric motors or generators, switching power sources or microprocessors. After rebooting, Turnkey quake modem use the new configuration parameter values. A ground plane may be made from a large metal sheet or several wires or rods radiating from the base of the radiator.